If you choose to invest in an electric water heater, you're going to want to make sure that your electrical system can accommodate the load. After all, such a device draws a lot of power so you're going to want to make sure that it can be adequately supplied.
If your home has a couple of bathrooms, you're going to want to choose a water heater that can adequately supply both of them at the same time. This is especially true if you have a big family as hot showers will most likely be in high demand.
What is standby energy loss? In terms of conventional water heaters, this is the energy expended to keep water at a set temperature even without demand. This means that the burner or heating element will continuously cycle on and off to maintain the thermostat setting.
If you live in a condo, there's certainly not going to be much room for a conventional water heater so you're going to want to use a tankless system. Because the tank is omitted, the space required is far less, thus allowing you to easily fit it in.
Heat pump water heaters work by taking the heat from the ground and the air and using it to heat water. As such, this type of heater isn't recommended for cold spaces as it will not be able to extract enough heat to do the job.
Condensing water heaters are much like conventional water heaters but they're far more efficient. This is because this type of heater captures hot exhaust gasses that would normally be vented out and blows it through a coil that heats incoming cold water.
If you live alone in a small condo or apartment, you're probably not going to need too much hot water so a single point water heater should be sufficient. This electric device is plumbed directly into your shower line and heats water as it passes through.
As water is heated in a tanked system, the pressure inside the vessel increases. As such, there will have to be some way to safely release it because an over-pressurized water tank will ultimately fail and may end up exploding violently.
Depending on where you live, you're going to have to choose the appropriate water heater that will work with the fuel source available. Gas-fed water heaters for instance, are ideal for places that have piped-in gas while electric heaters are the best choice for places without this service.
If you don't have the space for a conventional water heater, you may want to check out a tankless model. Like the name implies, these water heaters do not require a holding tank and can produce hot water on demand.
If you want to minimize your carbon footprint, you may opt for a solar-powered water heater. This type of heater makes use of roof-mounted panels with conductive copper pipes that absorb the heat of the sun. This heat is then transferred to the water as it passes through the pipes.
If you're planning on buying a water heater, your first consideration would have to be the number of people in your household. Choosing an underrated system can be very frustrating as there may never be enough hot water for everyone's needs.
There are four basic types of water heating systems, which can be combined in different configurations: Closed loop, Open loop, Active and Passive. The one to select depends on the demands of the building in which they are installed.
If you're looking for a water heater that won't drive up your electricity bill, one type you can opt for would be a heat pump. Unlike other water heaters, heat pumps don't use heating coils, but instead absorbs heat from the ground and air and transfers it to water.
Modern traditional tanks are as energy efficient as tankless systems, cost less to purchase, and cost about the same to operate over the same length of time.
Installing instant hot water heaters has become progressively easier, especially for electric models. All that is needed is sufficient wall space and access to a power source and water lines.
When renovating an old home or building, you want to make the plumbing fixtures as modern as possible without sacrificing the ambience. Both tank-style and tankless water heaters are available to match any architectural need.
If the space your water heater tank slots into is cramped, it may be very hard—if not impossible—to replace a conventional anode rod. As such, you're going to want to use a segmented anode rod to ensure that it can be removed and replaced even in tight quarters.
By adding a water heater, you can expand upon the the types of projects your pressure washing can bid on. Easy to use and install, they can easily fit on your flatbed trailer with the rest of your equipment.
The correct water heater for any home depends on a few factors: The number of people in the household, the number of appliances that use hot water, and the length of warranty for the water heater.
Water heaters, both tank-style and tankless, are available in natural gas, propane, electric and solar energy designs and models to meet the needs of any site's energy source.
All water heaters have a limited service life and at some point will need to be replaced. If you're not sure how old yours is, check the plate on the facing side, it will be posted there. If you have reached or surpassed the warranty age, it's time for a new one.
If you want instantaneous hot water from a water heater every time you turn on the tap, you will need to add a pump that keeps hot water circulating through the lines when not being used.
Like all of your household appliances, you're new hot water heater will need regular maintenance and inspection to ensure you get the longest life from the tank itself and to make sure all of the parts and connections are in good working order.
Has your water heater been acting wonky lately? Are there never-before-heard noises coming from it? Leaks around the base or the connections? These, and other issues, indicate it's time to replace it.
Eventually, hot water tanks begin to corrode. If not replaced, they will eventually crack (or even burst), and water will spill through the buidling. The damage that this water can create can easily exceed the price of a new tank. If yours is getting on in years, replace it with a new one.
What is a dip tube? In tanked water heater system, this is a pipe that introduces cold water into the tank. However, instead of filling from the top, these long tubes release water at the bottom of the tank so that it comes in contact with the surface that's being heated.
One of the most important components of a tanked water heater is its sacrificial anode rod. This long rod—usually aluminum or magnesium—is meant to absorb the corrosive elements that would otherwise wreak havoc on the tank itself.
Did you know that your water heater tank has an anode rod inside? It's purpose is to prevent the inside of the tank against corrosion. If yours has never been replaced, that's a good sign you'll soon need a new water heater.
Tankless water heaters take up less room than traditional tank systems and, because they are not heating water all day, do not raise the air temperature, which can keep cooling costs down.
Solar water heaters can reduce water heating costs by 35 to 60 per cent. Depending on the size of the system, installation costs can be recovered in seven to ten years.
Because tankless water heaters do not have storage tanks, they use less energy. They only use it when a hot water tap is turned on, and don't have to keep turning on and off to maintain a filled tank at the programmed temperature.
Having a good hot water heater in your home can make life more enjoyable and stress free. Adequate amounts of hot water at any given time of day is essential in the smooth operation of a household. There are tank-style and tankless models to meet any demand.
There are some extras available to help improve water heating ability. One of these is a “Quick Recovery” system that has an additional heating element at the top of the tank to provide a usable amount of hot water while the heating element at the bottom of the tank warms things up.
If the water from the water heater is coming out as too hot or not hot enough, it may be that the system needs recalibrating – especially if it's a gas system. If this doesn't fix it, then a new water heater is needed.
In a tankless water heating system, water passes over heated coils on the way to the tap. Temperature settings at the site of the heating element allow precise control over the water’s temperature.
Tankless water heaters are great for summer homes or weekend getaway sites. Because they don't store water, it can be shut off when no one is on site. This means no worries about the system freezing in winter.
You can save a great deal of money on your energy and water bills by changing from a tank-based water heater to a tankless system. You use less energy and water, and you have no worries about leaks from an old and failing tank.
The average amount of hot water an adult uses is 20-gal/day. To determine the size of the water heater you need, multiply the number of people in your household by twenty (figure children as adults). Typically, a family of four should have at least an eighty gallon system (but be sure to allow for family growth).
If you have low ceilings where you plan to install a water heater, look for "lowboy" models. These units are shorter but are bigger around and the same capacity as their taller counterparts.
On average, a conventional water heater with a storage tank lasts 10 years. The most common reason for replacement is that the storage tank fails because of corrosion.
Burning fuel to heat your water creates water vapor and carbon dioxide. So, in addition to a gas supply, natural gas water heaters need a venting system to remove these by-products.
“Cold water sandwich” is a term used to describe layers of hot and cold water in a home’s piping system. This happens when “off” and “on” water operations occur, for example, in the case of back-to-back showers.
Heat pump water heaters takes heat from the air and deliver it to water via electricity. For heat pump units to work efficiently, the outside temperature must be between 40- and 90-degrees Fahrenheit.
The first hour rating (FHR) displayed on the Energy Star label of your water heater is referred to as the recovery rate. This is the amount of water the unit can heat to the desired temperature in one hour.
Reducing water usage in multi-family buildings is not as overwhelming as it may seem. Installing tankless water heaters along with low flow showerheads, low -flush toilets, and other water-saving appliances can reduce water use by more than two-thirds.
On average, how long do tankless water heaters last? Tankless water heaters will normally give reliable service for 15 to 20 years. They also have easily replaceable parts that prolong their life expectancy by many more years.
In the United States, the best way to check the efficiency of any appliance is to check the yellow Energy Star label on the unit. This stands true for all modern appliances, including water heaters.
Do you know that about 25% of energy usage in a home comes from a water heater? Americans typically use between 80 and 120 gallons of hot water every day.
Did you know the idea of a water heater first originated in London in 1868? The credit goes to a painter who found a way to heat cold water by placing gas burners underneath water pipes.
Do you know that by choosing a high-efficiency water heater, instead of a standard water heater, you can cut your energy consumption by 10% to 50%?
Solar water heaters are best suited to areas that have plenty of sunshine. They can be used in combination with a conventional water heating system and can cut your water heating bill by as much as 80%.
Do you know that by choosing a high-efficiency water heater, instead of a standard water heater, you can cut your energy consumption by 10% to 50%?
Because tankless water heaters do not store water at a temperature that must be maintained, they are less expensive to operate. Moreover, without a tank, there is no chances of rupturing and flooding!
If there is a sudden smell of sulfur rising with the steam when the hot water is turned on, it is highly likely that the water heater anode rod needs replacing. If the anode is not replaced, it will shorten the service life of the hot water heater and leaking may develop.
Solar water heaters are best suited to areas that have plenty of sunshine. They can be used in combination with a conventional water heating system and can cut your water heating bill by as much as 80%.
Do you know that by choosing a high-efficiency water heater, instead of a standard water heater, you can cut your energy consumption by 10% to 50%?
Before the invention of modern water heaters, homes would use a pipe loop called a water-back to heat water. The loop was connected to the stove and as water was heated, it would move to a storage tank.
The installation costs of whole-house tankless water heaters are usually very high. However, their advantage is that if your home is not very spacious, tankless units can be mounted on the wall to save floor space.
Because tankless water heaters do not store water at a temperature that must be maintained, they are less expensive to operate. Moreover, without a tank, there is no chances of rupturing and flooding!
If there is a sudden smell of sulfur rising with the steam when the hot water is turned on, it is highly likely that the water heater anode rod needs replacing. If the anode is not replaced, it will shorten the service life of the hot water heater and leaking may develop.
Solar water heaters are best suited to areas that have plenty of sunshine. They can be used in combination with a conventional water heating system and can cut your water heating bill by as much as 80%.